13
1. Check fuse 16 a Part# 10064
2. Check electrical box
3. Check 115v cord
4. Check plug
5. Check remote control
1. Change fuse 16 a (white - on top)
2. Check for disconnection
3. Check for wire cut or disconnect
4. Check for wire disconnect
5. Check for wire disconnect
1. Bearing
Part#10198 & 10178
IA. Remove the pump from the tank
IB. Remove block pump
IC. Disassemble block pump
ID. Change bearing
2. Remote control handswitch small
white plastic support
2A. Open the handswitch 2B. Replace small plastic parts
Blown fuses when
starting
1. Check if fuse 16 a is blown Part#
10064
1A. To avoid the problem don’t run motor If hydraulic hose
are not connected
Hose or tool fitting is
damaged or leaks.
1. Broken or melted plastic outer
covering.
2. Frayed plastic strands.
3. Oil leaks through fibres.
4. Broken fittings.
1. If underlying plastic is still intact continue operation.
Inspect frequently.
2. Cut hose in half and discard. Replace hose.
3. Cut hose in half and discard. Replace hose.
4. Remove old fitting and replace with STEEL high pressure
fittings only. After changing fittings, always run test #5 to
insure proper plumbing.
Electric pump will not run
1. Loose electric connections in control
box.
2. Motor burned up.
3. Fuse
1. Open control box and visually inspect for loose threaded
or push-on connectors.
2. Replace motor components whichever is necessary.
SHOP JOB.
3. Change defect fuse
To Next Page
Loading...
