Operation Instructions 28
BP8000
Operation Instructions
Please read the safety tips carefully before operating the lift
To lift vehicle
1. Keep lift area clear of clutter;
2. Position lift arms to the lowest position;
3. Push lift arms all the way in;
4. Open lift arms;
5. Position vehicle between columns;
6. Move arms to the vehicle’s lifting point;
Note: The four lift arms must make contact on the lifting points of the
vehicle.
7. Press the UP button until the lift pads contact underside of vehicle totally.
Recheck to make sure vehicle is secure, centered, and not off balance;
8. Continue to raise the lift slowly to the desired working height, ensuring the
balance of vehicle;
9. Push lowering handle to lower lift onto the nearest safety. The vehicle is ready
to repair.
To lower vehicle
1. Keep the lift area free of clutter
2. Press the UP button to raise the vehicle slightly. Then release the safety lock
device, lower the vehicle by pushing down the lowering handle while holding
down the safety lock handle.
3. Open the arms and position them to the shortest length;
4. Drive the vehicle away.
5. Turn off the power.
To Next Page
Loading...
Need help?
General
