Operation Instructions 40
PV-12P
Operation Instructions
Please read the safety tips carefully before operating the lift
To lift vehicle
1. Be sure there are no obstructions near the lift area;
2. Position lift arms to the lowest position;
3. Open lift arms;
4. Position vehicle between columns;
5. Move arms to the vehicle’s lifting point;
Note: The four lift arms must make contact at the same time on the
vehicle’s lifting points and both axles must rise off of the ground at the
same time.
6. Press the UP button until the lift pads contact underside of vehicle. Check to
make sure vehicle is secure;
7. Continue to raise the lift to the desired working height, ensuring the balance
of the vehicle;
8. Push lowering handle to lower lift onto the nearest safety lock. The vehicle is
ready to repair. Note: The lift must always be on the safety locks!!!!!
To lower vehicle
1. Be sure there are no obstructions near the lift area;
2. Press the button of UP to raise the vehicle slightly, and then release the
safety device, lower vehicle by pushing the lowering handle.
3. Open the arms and position them to the shortest length;
4. Drive the vehicle away.
To Next Page
Loading...
Need help?
General
