EasyManuals Logo

Atlas SWC-500 User Manual

Default Icon
11 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
Troubleshooting
Problem Probable Cause Possible Remedy
Unit not working
Check fuse or circuit breaker
Check for correct voltage
Wiring connections
Replace blown fuse or reset circuit
breaker
Supply correct voltage to unit
Repair and insulate all connections
Pump motor not
operating
Pump breaker off
Broken wash timer
Broken door safety switch
Wiring connections
Bad motor starter
Pump is broken
Turn on breaker for pump
Replace timer
Replace switch
Repair and insulate connections
Consult electrician
Replace pump
Pump motor operates but
has little or no pressure
Water level is too low
Pump is rotating backwards
Pump is broken
Solution is foaming
Spray manifolds or filters are
clogged
Fill water to proper level
Consult an electrician
Replace pump
see below
clean out
Solution won’t get hot
Thermostat not set an correct
temperature
Broken heating element
Broken thermostat
Wiring connections
Adjust thermostat
Replace heating element
Replace thermostat
Repair and insulate connections
Poor cleaning
Incorrect detergent
Low detergent concentration
Hard water
Clogged nozzles
Solution is too dirty
Incorrect solution temperature
Low pump output
Use detergent designed for spray
wash cabinet.
Adjust detergent level
Use a water softener
Clean spray nozzles
Run oil skimmer or change solution
Adjust thermostat
See below
Wash table not turning
Pressure spring missing or broken
Worn friction drive wheel
Wiring connections
Motor windings burned out
Replace spring
Replace friction drive wheel
Repair and insulate connections
Replace motor
Rust inside cabinet
Wrong detergent
Did not follow start up procedure
Machine used too infrequently
Remove rust use detergent with
rust inhibitors
Remove rust, and change solution
using twice the normal detergent
level.
Remove rust, oil the inside of the
cabinet.
Solution is foaming
Wrong detergent
Started wash cycle when solution
was cold.
Concentration too low
Use low-foam detergent
Allow proper time for solution to
heat
Adjust detergent concentration
Add de-foamer

Table of Contents

Other manuals for Atlas SWC-500

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Atlas SWC-500 and is the answer not in the manual?

Atlas SWC-500 Specifications

General IconGeneral
BrandAtlas
ModelSWC-500
CategoryWasher
LanguageEnglish

Related product manuals