©2020 Atlas Sound LP. The Atlas “Circle A”, Soundolier, and Atlas Sound are trademarks of Atlas Sound L.P. IED is a Registered Trademark of Innovative Electronic Designs LLC. All rights reserved.
All other Trademarks are property of their respective owners. No endorsement is implied. Due to continual product development, specifications are subject to change without notice. ATS006331 RevA 11/20
AtlasIED.com
TELEPHONE: (800) 876-3333
SUPPORT@ATLASIED.COM
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
Date: 10-29-2020
Related AtlasIED product: WTSD-MIX31, Z Series, Atmosphere
Subject: Mobile Device Bluetooth Streaming ID Naming
Overview
With the recent release of Apple iOS 14 any Bluetooth™ device can now be re-named in the Bluetooth settings page while connected to the device.
The rename function is unique to your mobile device, it does not change the factory default name of the Bluetooth device you are connecting to.
Note: Android mobile devices have already offered the capability of renaming Bluetooth connections. See below for a quick list of steps for a
Samsung™ Tablet. Different Android versions vary and specific instructions can be found for many versions.
Application
When multiple models of the same Bluetooth AV device are used in an application, it can be challenging to identify the individual device to connect
to if the Bluetooth connection list shows identical names. Example: two or more WTSD-MIX31’s installed in adjacent Zones. The Bluetooth scan list
default name shows “Atlas Mix31” for both devices.
To Rename with an iOS Device (Using WTSD-MIX31 as Example)
1. Go to mobile device Settings, Bluetooth and turn ON Bluetooth (device search scanning will start)
2. Go to the first installed device (in this example, the WTSD-MIX31) and press the Bluetooth Music Connect / Disconnect button. It will begin
flashing a blue LED. Note: If LED is solid blue, a Bluetooth device is already connected to the WTSD-MIX31. To disconnect that device, press the
WTSD-MIX31 Bluetooth Music button, the blue LED will go off indicating that the device that was connected is disconnected. Repeat the
connection process and press Bluetooth Music Connect again. Then, in the search list, tap the “Atlas Mix31” default name to connect.
3. After connecting, the WTSD-MIX31 blue LED will go solid, indicating it is connected. Tap the blue info circle to the right on the connected list to
open the Name, Disconnect, Forget This Device page.
4. Tap on the Name to edit, type in the new name, and press “done” to save. Note: There are 14 total character spaces visible in the list when not
connected and 17 when connected.
5. Return to the Settings page to Exit.
AtlasIED Technote
Bluetooth Settings
Tap to Open Editor
WTSD-MIX31 Bluetooth Button Tap to go to Edit Page
Verify Name and Exit SettingsTap Done to SaveEdit Name
2
2
1
3
4
4
4
5
To Next Page
Need help?
General
