EElleeccttrriiccaal l ssyysstteemm 1100..1155
CCoonnnneeccttoorrs s iin n ccoolld d ssttoorraagge e rroooommss AATTLLEET T SSEERRVVIICCE E MMAANNUUAALL
1100.4.4 CCoonnnneeccttoorrs is in cn coolld sd stotorraagge re roooommss
0
0
1100..44..11 GGrreeaassiinngg
Grease Kryotox, ATLET article number 110781, should be Grease Kryotox, ATLET article number 110781, should be applied to all electricalapplied to all electrical
connectors in the machine housing, below the shelf where connectors in the machine housing, below the shelf where the computer and the ACthe computer and the AC
regulator are mounted. The exception is the two contactors located in the regulators.regulator are mounted. The exception is the two contactors located in the regulators.
Moreover, grease all contactors and the connector blocks in the Moreover, grease all contactors and the connector blocks in the mast and mast basemast and mast base
are greased on cold store are greased on cold store designed models. The hand spray, part number 110782,designed models. The hand spray, part number 110782,
should be used in order to do this.should be used in order to do this.
The grease should be applied to contactor surfaces when the The grease should be applied to contactor surfaces when the contactors are drawncontactors are drawn
apart. The connectors are then reconnected and the apart. The connectors are then reconnected and the grease is pressed from behindgrease is pressed from behind
into the connector housing so that this is filled. A connector block is regarded as allinto the connector housing so that this is filled. A connector block is regarded as all
blocks that have more than one cable. Flat pins that are protected by some form ofblocks that have more than one cable. Flat pins that are protected by some form of
casing are not to casing are not to be greased. This applies to the be greased. This applies to the connector blocks connected to theconnector blocks connected to the
valve.valve.
To Next Page
Loading...