10.22 10.22 Electrical Electrical systemsystem
AATTLLEET T SSEERRVVIICCE E MMAANNUUAALL MMaaggnneettiic c sswwiittcch h ffoor r tthhe e rreeaacch h ssttoopp
1010.8.8.2.2 ReReacach sh stotop dp damampiping ng (2(200005w5w0404÷÷))
(trucks with S3)(trucks with S3)
The purpose of the The purpose of the reach stop damping is make mast reach stop damping is make mast movement more gentle.movement more gentle.
Damping of reach-in movementDamping of reach-in movement
Damping of the reach-in movement is performed in two steps using two magneticDamping of the reach-in movement is performed in two steps using two magnetic
sensors.sensors.
1.1. SenSensor sor (A) (A) givgives es a a signsignal al for for redreduciucing ng reareach ch spspeedeed..
2.2. SenSensor sor (B) (B) givgives a es a sigsignal nal for for stopstoppiping tng the he reareach ch movmovemeement.nt.
3.3. MaMake oke othther ser setettintings vgs via tia the the truruck ck cocompmpututerer..
Figure 10.4Figure 10.4
A
A
BB
5252
To Next Page
Loading...