10.26 10.26 Electrical Electrical systemsystem
AATTLLEET T SSEERRVVIICCE E MMAANNUUAALL HHoorrnn
1100..1100 HHoorrnn
0
0
1010.1.100.1.1 CoConnnnecectitioonn
When connecting the horn the terWhen connecting the horn the terminals on the terminal minals on the terminal block should be turnedblock should be turned
towards you. Connected according to the standard wiring diagram.towards you. Connected according to the standard wiring diagram.
Setting the sound. Applies to trucks manufactured up until week 30 in 2001:Setting the sound. Applies to trucks manufactured up until week 30 in 2001:
A number of dipswitches labelled 1-5 can be found at the rear of the A number of dipswitches labelled 1-5 can be found at the rear of the horn. Thehorn. The
switches are set so that 1-3 switches are set so that 1-3 are closed and 4-5 are open. The tones obtained will are closed and 4-5 are open. The tones obtained will thenthen
be 970 Hz for the horn and 2850 Hz for be 970 Hz for the horn and 2850 Hz for the buzzer. There is also a potentiometerthe buzzer. There is also a potentiometer
screw that can be turned clockwise to the stop to give the screw that can be turned clockwise to the stop to give the maximum sound level.maximum sound level.
From week 31 2001 there is a new, electronic signal horn. This has a detachableFrom week 31 2001 there is a new, electronic signal horn. This has a detachable
buzzer above the horn and a higher level of sound.buzzer above the horn and a higher level of sound.
To Next Page
Loading...