10.6 10.6 Electrical Electrical systemsystem
AATTLLEET T SSEERRVVIICCE E MMAANNUUAALL IInnttrroodduuccttiioonn
•• All dusAll dust and mat and magnetignetic or metac or metallic pallic particlerticles must bs must be rege regularly ularly cleancleaned froed fromm
solenoid switches and solenoids to solenoid switches and solenoids to guarantee operation.guarantee operation.
•• ExtreExtreme impome importanrtance must ce must be plbe placed oaced on precan precautionutionary meary measureasures to avs to avoidoid
accidents during all work on the vehicle. A general rule is accidents during all work on the vehicle. A general rule is always to implementalways to implement
preventive measures that are adapted to the type of vehicle to be worked on.preventive measures that are adapted to the type of vehicle to be worked on.
The general rules below must always be The general rules below must always be observed:observed:
•• SmokiSmoking or nng or naked flaked flames arames are stricte strictly forbidly forbidden as thden as there is a rere is a risk of exisk of explosioplosion inn in
the vicinity of batteries the vicinity of batteries and while working on gas and while working on gas equipped vehicles. Theequipped vehicles. The
battery should always be protected during grinding work. battery should always be protected during grinding work. The fire regulationsThe fire regulations
for the building for the building should also be observed.should also be observed.
•• AlwayAlways lift the trus lift the truck so thck so that the drat the drive whive wheel is freeel is free of the groe of the ground to pund to prevenrevent thet the
vehicle from running away. The vehicle must not rest solely on the jack, butvehicle from running away. The vehicle must not rest solely on the jack, but
must be secured by some form of blocking.must be secured by some form of blocking.
•• AlwayAlways s remoremove thve the bae battery ttery plug plug to prto prevent event the rthe risk oisk of injuf injuries ries causcaused bed byy
crushing. The mast, carriage and hydraulic unit ccrushing. The mast, carriage and hydraulic unit can be actuated due to an be actuated due to anan
electrical fault or mistake while working. The battery plug may only beelectrical fault or mistake while working. The battery plug may only be
connected while trouble shooting and when the greatest of connected while trouble shooting and when the greatest of care is exercised,care is exercised,
(with the truck raised).(with the truck raised).
•• During During work owork on and arn and around thound the mast e mast and hyand hydrauldraulic unic unit, theit, these musse must be loct be lockedked
using a mast lock, wooden blocks or other appropriate material. No otherusing a mast lock, wooden blocks or other appropriate material. No other
persons may be in the vicinity of the truck when this persons may be in the vicinity of the truck when this is test run in combinationis test run in combination
with repair work, as there is a with repair work, as there is a risk of incidents and accidents occurring due torisk of incidents and accidents occurring due to
the truck the truck making an unexpected manoeuvre.making an unexpected manoeuvre.
Warning!Warning!
Standing on the reach carriage between the mStanding on the reach carriage between the mast and battery partition with theast and battery partition with the
current connected to the truck can resulcurrent connected to the truck can result in fatal injury!t in fatal injury!
•• The sysThe system shotem should nould not be presst be pressuriseurised, e.g. thd, e.g. the pump moe pump motor shutor shut off and tt off and thehe
forks down in forward tilt position when dismantling parts of forks down in forward tilt position when dismantling parts of the hydraulicthe hydraulic
system.system.
To Next Page
Loading...