10.88 10.88 Electrical Electrical systemsystem
Subinfo: ATC contradictory. e2048Subinfo: ATC contradictory. e2048
10.10.16.416.4 E10E100, E100, E101. Dr1. Drive syive system astem abnobnormalrmal/ Hydr/ Hydrauliaulicscs
abnormalabnormal
Subinfo: Controller calib error. w256Subinfo: Controller calib error. w256
Cut the voltage to the truck by pullingCut the voltage to the truck by pulling
out the battery plug, wait a fewout the battery plug, wait a few
seconds and switch on the voltageseconds and switch on the voltage
again.again.
Error code 2048 reoccurs after a newError code 2048 reoccurs after a new
start?start?
NoNo
Finished.Finished.
YYeses
Check that the Check that the AATC works aTC works as it should.s it should.
Change the regulChange the regulator.ator.
Cut the voltage to the truck by pullingCut the voltage to the truck by pulling
out the battery plug, wait a fewout the battery plug, wait a few
seconds and then switch on the voltageseconds and then switch on the voltage
again.again.
Warning code w 256 reappears afterWarning code w 256 reappears after
restarting the regulator?restarting the regulator?
YYeses
Change the pump or drive regulatorChange the pump or drive regulator
depending on which warning code hasdepending on which warning code has
been logged.been logged.
NoNo
Finished.Finished.
To Next Page
Loading...