10.96 10.96 Electrical Electrical systemsystem
E105 Sub info: Rotation sensor in motorE105 Sub info: Rotation sensor in motor
E105 Other faultE105 Other fault
1010.1.16.6.77 E1E10606, Pu, Pump smp sysystetemm
E106 Sub info: Input voltage too low E106 Sub info: Input voltage too low in the main circuitin the main circuit
In the case of intermittent faultsIn the case of intermittent faults
this may be due to the truck beingthis may be due to the truck being
shut down by the emergency stopshut down by the emergency stop
during operation.during operation.
Is the control cable between theIs the control cable between the
regulator and motor OK?regulator and motor OK?
YYeses
Replace motorReplace motor
Internal fault in the regulator.Internal fault in the regulator.
If the fault is permanent, replaceIf the fault is permanent, replace
the regulatorthe regulator
Battery OK?Battery OK?
šš
NoNo
Charge/replace the battery.Charge/replace the battery.
YYeses
Is the fuse for the drive regulatorIs the fuse for the drive regulator
intact?intact?
šš
NoNo
Replace the fuse. If the fuse blowsReplace the fuse. If the fuse blows
again, replace the regulatoragain, replace the regulator
YYeses
To Next Page
Loading...