P a g e | 20
The speed should be at least 200Mbps to get a full non-intermittent picture from the internet to
the receiver, any device that does not meet the min. requirement or type, will display an
unstable
picture and we won’t be responsible for any issues caused by the other device used.
a) Power Line Adapter:
It comes set of 2 devices, connect the 1
st
adapter to the router, and the 2
nd
adapter to the
receiver.
All you need is to plug the 2 adapters in any power source outlet.
Note: The adapter should be plugged directly on the wall, it should not be connected to any
extension cord or surge protector, as this won’t guarantee the operation of the devices. Read the
device manual of the device on how to use them.
b) UHF Remote Extender :
Currently, the remote control that comes with the receiver is only set to use infra-red signal to
operate, but if UHF operation is required so that the remote can operate without having to point
it di
rectly to the receiver, a uhf remote extender needs to be purchased to allow the remote to
be used in any room around the house.
To Next Page
Loading...