HAND BLOWER
WORKSHOP MANUAL
PAGE 1
ACN 000 583 924
For more details visit our Atom website: www.atomindustries.com
Phone: (02) 9810 0194 Fax: (02) 9810 6691
Email: info@atomindustries.com.au
Remove cylinder cover 3 Torx-20 screws. For GX-25, place
blade screwdriver under base of cover (above recoil starter)
and click cover off.
Remove handle cover by undoing 5 Torx-20 screws.
Lift out cable, or switch and switch wire.
MANUAL 780
To replace throttle cable, switch or switch wires
Fig. 101
To remove handle assembly
Fig. 102
Remove bracket holding cable
and wire (bracket not fitted on
# 831 model 2-Stroke Blower)
Reverse procedure to instal
new cable, or switch and
switch wire.
Hint: When refitting cylinder
cover, screw up lowest screw
first.
Fig. 103
Fig. 104
Use Torx-20 screwdriver, or long T-20 powered bit, which
fits into 3 recessed handle holes to undo 3 captivated
screws which attached the AV springs to casings.
Unscrew in sequence .
When refitting handle assembly, screw up in sequence
for easier completion.
1 2 3
1
2
3
For all Atom Blower models
1 2 3
To Next Page
Need help?
General