1 2
Get the app
Download the Atomi Sma app
from the App Store or Google Play.
Register
Follow the on-screen instructions and register an account.
v4.11/21
Atomi Sma
GET
Register
4
Add your Atomi Sma device
Press “Add Device” or the “+” sign and
select “Connect Device” on the popup that appears
Add Device
5
WiFi
Password
Continue
Select the right network
Enter your home WiFi name and
password, then press “Continue”
Make sure you’re connected to a 2.4GHz WiFi network
(Atomi Sma can’t connect to 5GHz networks).
If the popup does not appear, close the app and try again.
Still nothing? Read the “Troubleshooting” section on this user guide.
If not flashing, press and hold the WiFi buon for 10s to reset.
Make sure to allow access to Location (Android),
Bluetooth and Local Network (iOS).
Let’s get staed!
Sma WiFi
Ceramic Tower Heater
Quick Sta Guide
TO AVOID THE RISK OF AN ELECTRICAL SHOCK, always make sure that the
Sma Heater is unplugged from the electrical outlet before relocating,
servicing, or cleaning it.
CAUTION: To prevent an electric shock, match wide blade of plug to wide
outlet slot and fully inse.
When using electrical appliances, basic safety precautions should always be
followed to reduce the risk of fire, electric shock, and/or injury to people,
including the following:
1. READ ALL INSTRUCTIONS BEFORE USING.
2. The Sma Heater is hot when in use. To avoid burns, do not let bare skin
touch the hot suaces. Use the back handle of the heater when moving.
Keep combustible materials such as furniture, pillows, bedding, papers,
clothes, and cuains at least three feet (0.9 m) away from the front of the
heater and keep them away from the sides and rear.
3. Extreme caution is necessary when the heater is being used by or near
children and whenever the heater is le operating and unaended.
4. Do not operate if the cord or plug has been damaged, if the heater
malfunctions, or if it has been dropped or damaged in any manner.
5. Do not use outdoors.
6. The Sma Heater is not intended for use in bathrooms, laundry areas, nor
similar indoor locations. Never place the heater where it may fall into a
bathtub or water container.
7. Do not run the cord under carpeting. Do not cover the cord under throw
rugs, runners, or similar coverings. Do not route the cord under furniture or
appliances. Arrange the cord away from high-trac areas where it could
be tripped over.
8. To disconnect the Sma Heater, turn controls to “O”, then remove the
plug from the outlet.
9. Connect to standard outlets only.
10. Do not inse or allow foreign objects to enter any ventilation or exhaust as
this may result in an electric shock or fire. It may also damage the Sma
Heater.
11. To prevent possible fire, do not block air intakes or exhaust in any manner.
Do not use on so suaces like a bed where openings may be blocked.
POLARIZED PLUG
This Sma Heater has a polarized plug (one blade is
wider than the other).
As a safety feature to reduce the risk of electrical
shock, this plug is intended to fit in a polarized outlet
only one way. If the plug does not fully inse into the
outlet, try reversing plug.
IMPORTANT SAFEGUARDS
12. The Sma Heater has hot and arcing or sparking pas inside. Do not use
it in areas where gasoline, paint, or flammable liquids are used or stored.
13. Use this Sma Heater only as described in this user manual. Any other
use not recommended by the manufacturer may cause fire, electric
shock, or injury to people.
14. Always plug the Sma Heater directly into a wall outlet/receptacle. Never
use it with an extension cord or relocatable power tap (outlet/power strip).
NOTE: This appliance is for HOUSEHOLD USE ONLY.
ELECTRIC POWER
If the electric circuit is overloaded by other appliances, your Sma Heater
and/or appliances may not operate properly. The Sma Heater should be
operated on a separate electrical circuit from other operating appliances.
Before you begin
1. Remove tie from the power cord and unravel the cord. Keep the plastic
wrapping away from children.
2. Place the Sma WiFi Ceramic Tower Heater on the floor in the desired
location.
3. Know your Wi-Fi network and password.
4. Make sure that you are operating on:
• iPhone
®
8 or higher and iOS
®
8 or higher.
Any previous iPhone
®
or iOS
®
may experience slower connections.
• Android™ 4.1x or higher.
5. Make sure that you’re connected to a 2.4GHz Wi-Fi network (Atomi Sma
app can’t connect to 5GHz networks).
List of main pas
Control Buons
Control
Buons
Heat
Output
Intake
Vent
Power
Switch
Solid
Base
Timer
Swing
ECO
High
Low
°F
WiFi
Swing/Oscillation
Heater will rotate
70 degrees back and
foh when pressed.
Timer
Set timer to run from
1-12 hours. When using
this seing, heater will
power o aer the
selected hours.
Mode
Press to change
from LOW and HIGH.
Wi-Fi Buon
LED Display
ON/OFF
Aer power o,
the fan will
continue to work for
30s and then stop.
Temperature Control
Set desired room temperature.
Temperature will blink while adjusting. The heater
may take up to five seconds to respond.
3
Plug in your Atomi Sma device
Use the switch on the back to turn it on and
confirm that the indicator light is flashing.
WiFi
To Next Page
Need help?
General