10
AMP and CAB Selection
There is a 3-way toggle switch on the upper right of the hardware that allows you to select between
three different AMP model and CAB IR combinations. The editor allows you to select which amp
models and CAB IR files are assigned to each of the three selections. You might use the same amp
model for each, but a different CAB IR for each one. Or you might use different amp models for each,
but the same CAB IR for each one. It is totally up to you to decide what combination of amp model
and CAB IR you want to use for each of the three selections.
AMP - For each of the three selections you can choose between SOLID STATE, TUBE AMP, SVT, DI or
NONE. Selecting DI still adds some analog flavor to the signal, while selecting NONE adds nothing
and completely bypasses the AMP section.
CAB - For each of the three selections you can choose between FROM FILE or CAB 1-6. If you select
FROM FILE, a pop up window will appear allowing you to select a CAB IR file from a folder on your
computer. When you select a file, the name of the file will be displayed here. CAB 1-6 are CAB IR files
that are built in to the editor and are always available.
CAB 1 is 1x12
CAB 2 is 1x15
CAB 3 is 2x15
CAB 4 is 4x10
CAB 5 is 8x10 Boogie
CAB 6 is 8x10 SVT
To update the firmware on your bass box:
• 1. On the Atomic Amps website, click on the Support & Downloads tab at the top of the screen .
Then click on the bass box tools.
atomicamps.com/atomic-amps-support
• 2. Here you will find the latest editor software for Mac OS and Windows . (Minimum requirements:
Mac OS 10 .9 and above & Windows 7 and above .) (TBD)
• 3. Click on either the Mac or Windows icon and the editor will download to your downloads folder .
• 4. Power on your bass box and connect it to your computer via USB .
• 5. Launch the downloaded editor
software application .
• 6. The editor will show a message: Firmware Update Required-Select “Update Firmware” from the
menu. Follow those instructions . NOTE-DO NOT TOUCH ANY OF THE KNOBS OR BUTTONS ON
THE BASS BOX WHILE THE UPDATE IS LOADING!
• 7. When the update is complete the editor will show another message: Update Complete-Please
disconnect/reconnect power supply . Follow those instructions.
• 8. Your update is now complete!
• 9. The Support & Downloads page for the bass box also contains a System Restore file . Should
you ever need to restore the bass box to it’s factory settings . To do this, click on the System
Restore icon on the webpage to download the file . In the editor go to MENU-RESTORE and select
the file you downloaded . It is labeled BB.fbu. (TBD) NOTE-DO NOT TOUCH ANY OF THE KNOBS
OR BUTTONS ON THE BASS BOX WHILE THE UNIT IS RESTORING! When the procedure is finished
your unit will be restored to factory presets and settings.
To Previous Page
Loading...