because the attached battery is almost empty.
Note: If the ZATO is powered via USB PD only, the Battery Status up top will read "Not
Connected". If it is exclusively powered via a NP-F/L-Series battery, the USB PD Status will
read "Not Connected" instead.
Display:
The Display menu only contains one large horizontal slider, allowing you to adjust the
brightness/backlight strength of the ZATO CONNECT.
Date & Time:
In this menu, you can configure the ZATO's handling of the Date & Time.
By pressing on Time Format, you can switch from 24H to 12H time. Under Date Format, you
can change the way that the current date is displayed. Available formats are DD-MM-YYYY
To Next Page
Loading...
