14
Engraving
Material
Plastic
0.01 3000 80% Threshold NO
Leather
0.01 4000 100% Threshold NO
Aclic
0.01 6000 100% Threshold NO
Rubber
0.01 1000 100% Threshold NO
Oil
painting paper
0.02 2000 100% Threshold NO
Rock
0.01 1000 100% Filled NO
Quality
Speed
（mm / min）
Max-Power Image Mode
Needs to
be blackened
Remark：
1.The parameter table is only for the most widely used materials. Customers may need to t other uncommon
materials by themselves, or they can contact us to apply for testing.
2.PVector les line mode parameters：
Copper：Speed 500mm/m，acceleration 200,Natural color alumina：Speed 600mm/m，acceleration 200
Other materials：Speed 1000mm/m，acceleration 200
3.For engraving non-vector format les, please refer to the above parameter table.
To Next Page
Loading...