This product is an integral pa of the laser engraving machine system, and must be installed on the laser
engraving machine for use. And the product belongs to the class 4 laser products, the laser system itself must
meet the requirements of the latest version of IEC 60825-1, otherwise the product will not be used.
Do not look directly at the laser beam to avoid skin exposure to type 4 beams, especially in close proximity.
Youth under the age of 18 must have parental supeision during use. Do not touch the laser when it is at work.
High-intensity laser beams produce extremely high temperatures and a lot of heat, and caing may burn
the substrate. Ceain materials may catch re during engraving, producing gas and smoke. Do not leave the
machine unattended while the laser is powered on.
When using a laser for engraving, the material produces smoke, steam, paicles, and toxic substances in plastic
and other combustible materials. These smoke or air pollutants can be harmful to your health.
Before using the laser for engraving, make sure that there are no ammable and explosive substances in the
caing area and always place available re extinguishers nearby to ensure safety.
Do not power on before the laser being installed to the engraving machine.
Please avoid machine vibration, machine vibration will cause the optical path to be inaccurate, resulting in
dangerous drift beam.
It is recommended to use at an ambient temperature of 20°C-30°C, lower or higher than the recommended
temperature will make the laser work unstable.
01.
02.
03.
04.
05.
06.
07.
08.
Cautions
01
To Next Page
Loading...
Need help?
General
