10
more dust. 2. Vigorously “TapClean” the HEPA
2. The shake-out bag is hand wash- pre-motor filter on a hard surface to
able in lukewarm water. remove any residual dust that might
3. Allow to air dry for 24 hours. The still be on the HEPA pre-motor filter.
shake-out bag should be replaced 3. You can wash the HEPA pre-motor
when needed. Never replace into filter by running it under the tap and
the vacuum if still wet. allowing the water to run on the dirty
Note: If used often without HEPA dust side at least once a month or when
bag, replacement and washing will be suction appears to be decreased.
required more often
4. Replace clean shake-out bag in
unit ,and replace the canister lid
onto the vacuum.
To Next Page
Loading...
