Atten AT8586D User Manual

Ensure safety by using original parts or accessories; unapproved items may cause serious issues.

The rework station must be repaired by qualified technicians or an appointed person.

Plug into a three-hole grounding outlet; do not alter or use ungrounded adapters.

Operate carefully above 400°C; avoid flammable areas and hot parts.

Do not leave the hot air rework station unattended while it is working.

Do not install the nozzle until the heating pipe and nozzle are cooled.

Keep input and output air draughts unblocked for proper operation.

Cool machine, place handle, and power off when idle to ensure safety.

Use iron tip solely for soldering; avoid using it for cleaning or scraping.

Ensure good ventilation during soldering as it produces smoke.

Details input voltage, power consumption, temperature range, air volume, and stability.

Details input voltage, power consumption, temperature range, stability, ground impedance, and voltage.

Steps for installing the handle frame and its components before first use.

Instructions for connecting the rework handle and plugging in the power cord.

Guide on turning on the device and the initial LCD display status.

Instructions for operating both rework and soldering stations, including display indicators.

Guide on adjusting and setting desired temperatures for the rework station.

Procedure for calibrating temperature after heating element or tip replacement.

Explanation of the sleeping state for the rework station when the handle is idle.

Instructions for waiting state, switching between Celsius/Fahrenheit units.

Explains error codes "H-E" and "S-E" for heating element and sensor issues.

Step-by-step guide for replacing the heating element of the rework station.

Critical warnings and attention points during heating element replacement.

Steps to replace the heating element of the soldering station.