2
Connections
To avoid electric shocks during installation, always switch of the amplifier power when connecting
loudspeakers.
A 4 core connection cable comes out of the cable gland, on top of the loudspeaker. By connecting the
appropriate cable cores, the desires power taps for the loudspeaker can be selected, to be used in 100V
public address applications.
Connections for 100 Volt use:
COM Blue
20 Watt Red
10 Watt Yellow
2.5 Watt Green
Always connect the – pole of the amplifier output to the COM (Blue core). The + pole of the amplifier
can be connected according to the table above for the desired output power.
When the loudspeaker is connected to 70.7V facilities, the power indicated in the table above will be
reduced to half the power, and when connected to 50V facilities, the power will be reduced to a quarter.
When the desired power tap is selected and connected, the loudspeaker is ready to be used.
To Next Page
Loading...