Audi 2008 A6 Quattro - Operating the VAS 5051 Diagnostic Tester; Tester Initialization and Readiness Confirmation; Component Adaptation Procedures After Replacement

Fig. 464: Identifying Volkswagen Tester VAS 5051, On Switch
Courtesy of VOLKSWAGEN UNITED STATES, INC.
 Switch on tester - arrow -.
Tester is ready for operation when it displays buttons for its operating modes.
 Switch on ignition.
 Touch Guided Fault Finding on screen.
 Select one after another:
 Brand
 Model
 Model year
 Version
 Engine identification
 Confirm entered data.
Then
 "Suspension".

"Level control system".
NOTE:
 If control modules or electric/electronic components were replaced, then
Adaptation of the component must be performed in general in "Guided
Fault Finding".
NOTE:

Wait until tester has checked all control modules installed in the vehicle.
 Press Goto button and select "Function/component selection" function.
2008 Audi A6 Quattro
SUSPENSION Suspension, Wheels, Steering
FIXYOURCAR
1:42:00 AM Page 6