Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
10.3 - Removing and installing ignition/starter switch
Removing
- Remove steering column switch => Page 140 .
- -> Unplug connector -1- at ignition/starter switch.
- Remove locking compound from both bolts -arrows-.
- Slacken off bolts -arrows- slightly and pull ignition/starter switch out of steering lock housing -2-.
Installing
Install in reverse order, paying attention to the following:
Note:
On installation, ignition/starter switch and lock cylinder must be in same position, e.g. "ignition ON".
- -> Secure bolts -arrows- at steering lock housing -2- with locking compound.
10.4 - Connection assignment at ignition/starter switch
Audi A3 1997 ➤
Electrical system - Edition 10.2003
148 94 - Lights, Lamps, Switches - exterior
To Next Page
Loading...
