Audi A3 1997 - Removing and Installing Interior Monitor Control Unit

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing
- Remove B-pillar trim.
=> General Body Repairs, Interior; Repair Group 70; Trim; Removing and installing B-pillar trim Trim Removing
and installing B-pillar trim
- Unplug connector.
- -> Unscrew ultrasonic sensor -1- from B-pillar trim -arrows-.
Installing
Install in reverse order.
13.3 - Removing and installing interior monitor control unit
Fitting location: Interior monitor control unit is located at rear left of luggage compartment.
Removing
- Open left luggage compartment storage area.
- -> Screw out bolts -3- and detach interior monitor control unit -1-.
2 - Speed nut
Installing
Install in reverse order.
Audi A3 1997 ➤
Electrical system - Edition 10.2003
13.2 - Removing and installing ultrasonic sensors for interior monitor 157