Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
- -> Unplug connector -2-.
- Unscrew wire -1- at alternator.
- Unscrew clamp at alternator.
- -> Screw out bolts -arrows-.
- Take out alternator.
Installing
Install in reverse order, paying attention to the following:
- To facilitate positioning of alternator, drive back bushings for retaining bolts slightly.
- Make sure ribbed belt is properly positioned and correctly routed.
- -> Ribbed belt routing on vehicles with no air conditioner
Audi A3 1997 ➤
Electrical system - Edition 10.2003
2.3 - 1.8l turbo engine - Audi A3 25
To Next Page
Loading...
