Audi A3 1997 - Removing and Installing Ribbed Belt Pulley Without Free-Wheel

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.9 - Removing and installing ribbed belt pulley without free-wheel
Special tools and workshop equipment required
◆ Socket attachment 3310
Removing
- -> Support nut with socket attachment 3310 and turn alternator shaft clockwise.
- Detach ribbed belt pulley.
Installing
Install in reverse order, paying attention to the following:
- Turn alternator shaft anti-clockwise.
Tightening torque
Component Nm
Ribbed belt pulley to alternator 65
Audi A3 1997 ➤
Electrical system - Edition 10.2003
2.9 - Removing and installing ribbed belt pulley without free-wheel 41