Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.10 - Removing and installing ribbed belt pulley with free-wheel
Special tools and workshop equipment required
◆ Multi-point adapter 3400
Removing
- -> Support pulley with multi-point adapter 3400 and turn alternator shaft clockwise.
Installing
Install in reverse order, paying attention to the following:
- Turn alternator shaft anti-clockwise.
- Clip protective cap onto free-wheel pulley.
Tightening torque
Component Nm
Ribbed belt pulley with free-wheel to alternator 80
Audi A3 1997 ➤
Electrical system - Edition 10.2003
42 27 - Starter, Current supply
To Next Page
Loading...
