EasyManua.ls Logo

Audi A3 1997 - Adaption

Audi A3 1997
245 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Measured value block 024
Display group 24 ◂ Indicated on display
X X X X ◂ Display zones 1 ... 4
The transponder identification disabled time indicates the period
after which transponder identification is again possible; this dis‐
able function is activated if the transponder of a non-authorised
key has been read out on 20 consecutive occasions
▪ 0 ... 10 min
The emergency release disabled time indicates the period after which PIN
can be entered again via menu function in dash panel insert (emergency
starting function without VAG 1551); control unit is disabled for 10 1) minutes
if PIN is entered incorrectly three times
▪ 0 ... 255 min
The engine control unit disabled time indicates the period after which adaption function
can be implemented again by engine control unit; control unit is disabled for 10 minutes
1) if PIN is entered incorrectly three times during channel 50 adaption
▪ 0 ... 255 min
The dash panel insert disabled time indicates the period after which login procedure can be imple‐
mented again at dash panel insert; control unit is disabled for 10 minutes 1) if PIN is entered incorrectly
three times during login procedure (matching of vehicle keys or old dash panel insert)
▪ 0 ... 255 min
1) Time is doubled up to max. 255 minutes after every 3 further incorrect attempts
Measured value block 025
Display group 25 ◂ Indicated on display
X - - - ◂ Display zones 1 ... 4
CAN communication with engine control unit
▪ 1 = Yes
▪ 0 = No, i.e. no CAN communication between immobilizer and engine control units - key matching
not possible
6.9 - Adaption
Note:
Adaption function can only be implemented after establishing immobilizer PIN => Establishing PIN, Page
176 .
The adaption function can be used to make and save the following changes:
Matching of vehicle keys => Page 176
Adaption following replacement of dash panel insert => Page 182
Adaption following replacement of engine control unit=>Page 188
Audi A3 1997
Electrical system Self-diagnosis - Edition 02.2002
6.8 - Reading measured value block 175

Table of Contents

Other manuals for Audi A3 1997

Related product manuals