Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
- Touch ▸ key.
-> Display on VAS 5051:
A - Control element test over
- Terminate function "03 - Final control diagnosis" by touching ◂ key.
9.7 - Basic setting
Basic setting must be performed following replacement of headlight, axle sensor or control unit. Heed the
following:
Notes:
◆ Vehicle must be in a precisely defined load status.
◆ For information on specifications and load requirements:
=> Maintenance
Sequence of operations
- Achieve uniform extension of suspension by moving body up and down several times at each wheel and
allowing vehicle to settle.
- Start automatic headlight range control self-diagnosis=>Page 225 .
-> Display on VAS 5051:
- From list -1- select diagnosis function "04 - Basic setting".
Audi A3 1997 ➤
Electrical system Self-diagnosis - Edition 02.2002
9.6 - Final control diagnosis 231
To Next Page
Loading...
