Audi A3 2024 - Predictive Control and Lane Guidance

8Y0012721BE
Driver assistance
The braking effect by the adaptive cruise assist is
not strong enough to maintain a sufficient dis-
tance to the vehicle driving ahead in this situa-
tion.
The display @ also appears if you have opened
the Driver assistance display in the trip computer
page 18.
Steering intervention requests
If the [MJ indicator light turns on, take over steer-
ing. The limits of the system have been reached,
for example because the system’s steering power
is not sufficient in curves that are too narrow. The
system will become inactive after a short time
and will only become available again later.
tf the [J or J indicator lights turn on and a cor-
responding message appears, take over steering.
Sufficient steering activity was not detected or a
system limit has been reached. Keep your hands
on the steering wheel so you can be ready to
steer at any time. If you do not take over steer-
ing, adaptive cruise assist will be canceled. If the
vehicle is equipped with emergency assist and it
is
ready to function, it will be activated
page 146.
WARNING
— Observe the safety precautions and note the
limits of the assist systems, sensors, and
cameras > page 115 to > page 118.
~The adaptive cruise assist is only an assist
system, and the driver is still responsible for
vehicle operation. The driver is especially re-
sponsible for braking, steering, and main-
taining the distance to other vehicles.
@ Tips
— Always keep your hands on the steering
wheel so you can be ready to steer at any
time. The driver is always responsible for
adhering to the regulations applicable in
the country where the vehicle is being oper-
ated.
— The intervention requests may be accompa-
nied by additional audio or visual signals,
depending on the situation.
Predictive control
Applies to: vehicles with adaptive cruise assist and predictive
control
Fig. 92 Instrument cluster: speedometer: predictive con-
trol display
General information
With predictive control, efficiency assist adapts
the set speed in adaptive cruise control @ based
on detected speed limits and the upcoming
route. Once the system no longer detects any in-
cidents, adaptive cruise control will accelerate
again to the last speed that you set. After switch-
ing on the ignition, the availability of predictive
control is indicated by a message when the adap-
tive cruise assist is first activated.
Incident symbols indicate the situation to which
predictive control is reacting ® page 127, Situa-
tion symbols.
Requirements
~The predictive control is turned on in the Driver
assistance menu under Adaptive cruise assist
= page 118.
— The adaptive cruise assist must be actively reg-
lating ® page 130.
—The system can only react to speed limits that
are 15 mph (20 km/h) or higher.
—The map content of the navigation system*
must be updated regularly in order for the sys-
tem to work without restrictions page 187.
Display in the speedometer
The display depends on vehicle equipment and is
not available in all layouts*.
@ The marking shows the set speed (regulated
speed that was set by you or by the predictive
control).
@® The red band shows the difference between
the speed limit and the set speed that is set. >
133
OwnersManuals2.com