Audi A3 2024 - Page 139

8Y0012721BE
Driver assistance
accident, always make sure there are no ob-
stacles between your vehicle and the vehicle
driving ahead.
For safety reasons, adaptive cruise assist only
starts driving actively if:
~The driver's safety belt is fastened,
~All doors and the hood are closed
~The vehicle has not been stationary for a
long period of time
Adjusting the adaptive cruise assist
Applies to: vehicles with adaptive cruise assist
You can adjust the adaptive cruise assist to your
preferences in the Driver assistance menu
page 118. The settings depend on the vehicle
equipment.
Possible settings:
Store last distance - The last distance that was
set will be stored after the ignition is switched
off. If the distance is not stored, distance [Eq]
(time distance of approximately 1.8 seconds) is
automatically preset every time the ignition is
switched on.
Applies to: vehicles without Audi drive select
Driving program - Depending on the selected
driving program and distance, the vehicle han-
dling will be adjusted from Sport to Comfort.
Applies to: vehicles with Audi drive select
Vehicle handling will be adjusted based on the
set distance and the selected Audi drive select
mode © page 106.
Predictive control > Set speed limit - adaptation
to speed limits can be switched On or Off. Regu-
lation With tolerance can also be selected, if de-
sired. In this scenario, you may fall below or ex-
ceed the set speed in favor of increased efficien-
9.
Predictive control > Adjustment to curves along
route - regulation based on the road ahead can
be switched Off or set from Slow to Fast based
on your preference. The setting influences vehicle
handling with predictive control, for example the
speed for driving through curves.
Messages
Applies to: vehicles with adaptive cruise assist
If Ei) or Bis displayed when there is a malfunc-
tion, the adaptive cruise assist functions may be
unavailable or limited.
A message that indicates the cause and possible
solution may appear with some displays. The
weather conditions may be too poor or a sensor
may be covered. Clean the area in front of the
sensors > page 117 and try to turn on the sys-
tems again later.
If the malfunction remains, drive to an author-
ized Audi dealer or authorized Audi Service Facili-
ty immediately to have the malfunction correct-
ed.
The following messages may appear depending
on the vehicle equipment:
Adaptive cruise assist: please take over!
This message appears if the vehicle rolls back
when starting on a slight incline, even though the
systems are active. Press the brake pedal to pre-
vent the vehicle from rolling or starting to move.
137
OwnersManuals2.com