EasyManua.ls Logo

Audi A3 2024 - Charging the 12 Volt Vehicle Battery

Audi A3 2024
310 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Checking
and
Filling
Never
make
modifications
to
the
lithium
battery.
Never
open
the
48
volt
battery.
Charging
the
12
volt
vehicle
battery
Fig.
141
Engine
compartment:
connections
for
the
charg-
ing
device
or
the
jump
start
cable (vehicles with
battery
in
the
engine
compartment)
Fig.
142
Engine
compartment:
connections
for
the
charg-
ing
device
or
the
jump
start
cable
(vehicles
with
jump
start
connection
in
the
engine
compartment)
Observe
the
safety
precautions
>
page
278,
Gen-
eral
information,
Z\
in
Battery
general
infor-
mation
on
page
230
and
>
A\.
Requirement:
only
use
chargers
with
a
maximum.
charging
current
of
14.8
volts.
The
battery
ca-
bles
remain
connected.
Depending
on
the
engine,
the
battery
may
be
lo-
cated
in
the
engine
compartment
or
in
the
lug-
gage
compartment.
A
jump
start
connection
(+)
is
located
in
the
engine
compartment
for
vehicles
with
the
battery
in
the
luggage
compartment.
This
jump
start
connection
(+)
is
used
to
charge
the
battery
as
well
as to
jump
start
the
vehicle.
The battery
is
always
charged
in
the
engine
com-
partment
©
page
221,
fig.
135.
The
ground
point
©
iis
always
located
on
the
vehicle
body.
232
>
Switch
off the
ignition
and
all
electrical
equip-
ment.
>
Open
the
hood
©
page
220.
»
Applies
to:
vehicles
with
battery
in
the
engine
compartment:
Open
the
cover
on
the
positive
terminal
©
fig.
147.
>
Applies
to:
vehicles
with
jump
start
connection
(+)
in
the
engine
compartment:
Open
the
cover
on
the
positive
terminal
©
fig.
142.
»
Clamp
the
terminal
clamps
on
the
charger
cor-
rectly
onto
the
positive
terminal/jump
start
connection
@
and
the
ground
point
©.
»
Insert
the
power
cable
for
the
charger
into
the
socket
and
switch
the
charger
on.
»
At
the
end
of
the
charging
process,
switch
the
charger
off
and
pull
the
power
cable
out
of
the
socket.
»
Remove
the
charger
terminal
clamps.
>
Close
the
cover
on
the
positive
terminal.
>
Close
the
hood
©
page
220.
Never
use
charging
equipment
that
is
un-
suitable,
visibly
damaged,
and/or
dirty.
Check
the
charging
equipment
for
damage
before
every
use.
~
Applies
to:
vehicles
with
jump
start
connec-
tions
in
the
engine
compartment:
The
charging
cable
or
jump
start
cable
must
nev-
er
be
connected
directly
to
the
12
Volt
vehi-
cle
battery.
Only
use
the
connections
in
the
engine
compartment
>
page
232.
~A
highly
explosive
mixture
of
gases
can
form
when
charging
batteries.
Only
charge
the
battery
in
well-ventilated
areas.
~A
drained
battery
can
freeze
at
tempera-
tures
around
32
°F
(0 °C).
Do
not
charge
or
use
a
frozen
or
thawed
battery.
If
ice
forms,
the
battery
housing
can crack
and battery
electrolyte
fluid
can
leak,
which
increases
the
risk
of
an
explosion
and
chemical
burns.
Contact
an
authorized
Audi
dealer
or
author-
ized
Audi
Service
Facility
for
more
informa-
tion.
=
Do
not
connect
or
disconnect
the
charging
cable
while
charging
because
this
increases
the
risk of
an
explosion.
>
OwnersManuals2.com

Table of Contents

Related product manuals