50 Lig hts an d Vi sion
@ Tips
- If the light reaching the rearview mirror
is obstructed, the automatic dimming
mirror will not function correctly,
- The automatic dimming mirrors do not
dim when the interior lighting is turned
on or the reverse gear is selected .
Digital compass
Switching the compass on and off
Applies to vehicles: with digita l compass
Fig. 40 Rearview m irror : d igit al compass activated
"To turn the compass on or off , press the but-
ton @ unt il the compass in the mirror ap-
pears or disappears .
The digi t al compass only works when t he igni-
tion is turned on. The directions are indicated
with abbreviations :
N (north), NE (northeast),
E (east), SE (southeast), S (south), SW (south-
west),
W (west), NW (no rthwest) .
You must recalibrate the compass if it does
not display the correct direction ¢
page 50,
Calibrating the compass .
(D Tips
To prevent inaccurate compass readings,
do not bring any remote controls, electri-
cal devices or meta ll ic objects near the
mirror.
Adjusting the magnetic zone
Applies to vehicles: with digital compass
The magnetic zone mu st be adjusted correctly
for the compass to read accurately .
Fig. 41 North Am erica: magnet ic zone map
• Press and hold the button @ ¢ page 50,
fig . 40 until the number of the magnetic
zone appears in the rearv iew mirror .
• Press the button @ repeat edly to select the
correct mag netic zone . The select ion mode
turns
off after a few seconds.
Calibrating the compass
Applies to vehicles: with digital compass
You must recalibrate the compass if it does
not display the correct direction.
• Press and hold the button @ ¢ page 50,
fig. 40
unti l a C appea rs in the rearview mir-
ror.
• Drive in a circle at about 5 mph (10 km/h)
until a direction is displayed in the rearview
mirror.
A WARNING
-
- To avoid endangering yourse lf and other
drivers, calibrate the compass in an area
where there is no traffic .