Clear vision
Applie s to vehicles: with sun shade
Sun shade
Rear door sun shade*
Fig. 56 with MMI :
Butto n for rear window
sun shade
Fig. 57 without MMI:
Butto n for rear window
sun shade
- Pull the sun shade out and attach it to the hooks on the
upper door frame.
Rear window sun shade*
- To extend/retract the sun shade, press the button~
=> fig. 57 . In vehicles with MMI*, the button is located
above the climate control system => fig. 56 .
The rear window sun shade can be set in the MMI* so that it retracts
automatically when driving in reverse. Select
I CARI> Window > Rear
window sun shade
> On to do this. The sun shade is extended again
as soon as the vehicle is t raveli ng fo rward at a speed greate r than
9 mph (15 km/h) if the ign ition has not been switched off in the
meantime. The current setting is automatically stored and assigned
to the remote key.
[I] Tips
• Press ing the button Q;;I several times consecutively can tr igger the
overload protection. The sun shade can only be extended/retracted
aga in after a brief wa iting pe riod .
• The rear window sun shade only functions when the vehicle inte-
rio r is wa rme r t han
14°F (-10°(). •
Wiper and washer system
Switching on the windshield wipers
Fig. 58 Windshield
wiper lever
Move the windshie ld wiper lever to the correspond ing pos ition:
@ -Windshield wiper off
(D - Interval mode . To extend/shorten the wiper interva ls, move the
switch @ to the left/r ight . In vehicles with a rain sensor* , the wind-
shield wipers are activated automat ically starting at a speed of 2 mph
(4 km/h). The higher the sensitivity of the ra in sensor* is set (switch
9J,,
To Next Page
Loading...
