Audi A4 2015 - Removing and Installing Selector Lever Handle

– Take release tool -1- out of vehicle tool kit.
– Insert release tool into mounting -2- for manual release mech‐
anism, as shown in illustration.
– Turn release tool 90° -arrow B- and at the same time, press it
down -arrow A- until it engages.
• Parking lock is now released.
Note
♦ When the manual release mechanism for the parking lock has
been operated, position “N” will be indicated in the instrument
cluster.
♦ The following message will also appear in the instrument clus‐
ter: “Vehicle may roll away! P cannot be selected. Please apply
parking brake.”
Reactivating parking lock
Note
The following steps are required in order to reduce the release
force and facilitate operation:
– Press brake pedal, start engine and move selector lever
through N > D > N.
– Switch off engine, grip wrench with both hands and pull up‐
wards.
– Press brake pedal, start engine and move selector lever
through N > D > N.
Note
When the parking lock is engaged, the instrument cluster and the
selected range display - Y5- should show the position “P”.
1.5 Removing and installing selector lever
handle
Note
The selector lever handle is removed together with the selector
lever boot.
Special tools and workshop equipment required
Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
1. Selector mechanism 25