Audi A4 2015 - Detaching and Attaching Selector Lever Boot on Selector Lever Handle; Removing and Installing Selector Mechanism

Installing
Installation is carried out in reverse order; note the following:
– Check that retaining clips -arrows- on underside of selector
lever handle (top section) -1- are correctly seated; press down
further if necessary.
– Press selector lever handle (top section) onto selector lever
handle (bottom section).
– Clip selector lever boot onto selected range display - Y5- .
– Check selector mechanism ⇒ page 17 .
Tightening torques
♦ ⇒ “1.1 Exploded view - selector mechanism”, page 13
1.6 Detaching and attaching selector lever
boot on selector lever handle
Disconnecting
– Remove selector lever handle ⇒ page 25 .
– Release catches -arrows- and detach selector lever boot -1-
from selector lever handle.
Attaching
– Press selector lever boot onto selector lever handle until you
hear it engage.
• Lug -2- on selector lever boot must engage in notch -1- on
selector lever handle -arrow-.
– Install selector lever handle ⇒ page 25 .
1.7 Removing and installing selector mech‐
anism
Special tools and workshop equipment required
Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
1. Selector mechanism 27