Audi A4 2015 - Page 35

– Remove nuts -3-.
– Release catches -arrows- and lower manual release retainer
-2-.
– Remove noise insulation (rear) ⇒ General body repairs, ex‐
terior; Rep. gr. 66 ; Noise insulation; Removing and installing
noise insulation .
– Depending on equipment version: Remove underbody trim
(tunnel) ⇒ General body repairs, exterior; Rep. gr. 66 ; Un‐
derbody trim; Exploded view - underbody trim .
– Remove heat shield for tunnel and place down on propshaft
⇒ General body repairs, exterior; Rep. gr. 66 ; Strips / trim
panels / extensions; Exploded view - heat shield .
– Unscrew bolts -arrows-, detach parking lock manual release
cable -1- and move cable clear.
Installing
Installation is carried out in reverse order; note the following:
Note
♦ Manual release cable -2- should not be in contact with parking
lock lever -1- to avoid transmission of mechanical vibration.
♦ Manual release cable -2- should therefore be aligned so that
there is a small clearance of dimension -a- and -b-.
– Install centre console ⇒ General body repairs, interior; Rep.
gr. 68 ; Centre console; Removing and installing centre con‐
sole .
– Check manual release mechanism for parking lock
⇒ page 22 .
Tightening torques
♦ ⇒ “1.2 Exploded view - manual release mechanism for parking
lock”, page 16
♦ ⇒ General body repairs, exterior; Rep. gr. 66 ; Strips / trim
panels / extensions; Exploded view - heat shield
♦ ⇒ General body repairs, exterior; Rep. gr. 66 ; Underbody
trim; Exploded view - underbody trim
♦ ⇒ General body repairs, exterior; Rep. gr. 66 ; Noise insula‐
tion; Exploded view - noise insulation
Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
1. Selector mechanism 31