Audi A4 2015 - 1.2 Engine, Securing to Engine and Transmission Holder

– Remove nuts -arrows-.
– Move parking lock manual release cable (rear) -1- clear and
detach.
Installing
Installation is carried out in reverse order; note the following:
– Install centre console ⇒ General body repairs, interior; Rep.
gr. 68 ; Centre console; Removing and installing centre con‐
sole .
– Install sill panel trim (driver side) ⇒ General body repairs, in‐
terior; Rep. gr. 70 ; Passenger compartment trim panels;
Removing and installing sill panel trim .
– Install foot rest ⇒ General body repairs, interior; Rep. gr. 70 ;
Passenger compartment trim panels; Removing and installing
foot rest .
– Install footwell cover (driver side) ⇒ General body repairs, in‐
terior; Rep. gr. 68 ; Storage compartments/covers/trim panels;
Removing and installing dash panel cover (driver side) .
– Install driver’s seat ⇒ General body repairs, interior; Rep. gr.
72 ; Front seats; Removing and installing front seat .
– Check manual release mechanism for parking lock
⇒ page 22 .
Tightening torques
♦ ⇒ “1.2 Exploded view - manual release mechanism for parking
lock”, page 16
♦ ⇒ General body repairs, exterior; Rep. gr. 66 ; Noise insula‐
tion; Exploded view - noise insulation
1.9 Removing and installing parking lock
solenoid - N486- / gear sensor - G676-
Special tools and workshop equipment required
♦ Press tool - 3276A-
Removing
– Remove noise insulation (rear) ⇒ General body repairs, ex‐
terior; Rep. gr. 66 ; Noise insulation; Removing and installing
noise insulation .
– Remove mechatronic unit
⇒ “10.3 Removing and installing mechatronic unit”,
page 102 .
Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
1. Selector mechanism 33