Audi A4 2015 - Page 48

– Remove bolts -2 … 5- securing gearbox to engine (accessible
from above).
Vehicles with four-wheel drive
– Remove propshaft ⇒ Rear final drive; Rep. gr. 39 ; Propshaft;
Removing and installing propshaft .
All vehicles (continued)
– Detach intermediate steering shaft from steering rack and
slide together ⇒ Running gear, axles, steering; Rep. gr. 48 ;
Steering column; Removing and installing intermediate steer‐
ing shaft .
– Remove bolts -arrows- securing coolant pipe for gearbox.
– Support engine in installation position ⇒ Engine; Rep. gr. 10 ;
Assembly mountings; Supporting engine in installation posi‐
tion .
– Clamp off coolant hoses using hose clamps up to 25 mm -
3094- and disconnect hoses (release hose clips -1, 2-).
– Remove subframe shield -arrow- (below drive shaft on both
sides) ⇒ Running gear, axles, steering; Rep. gr. 40 ; Sub‐
frame; Removing and installing subframe shield .
Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
44 Rep. gr.34 - Controls, housing