Vehicles with 4-cyl. TFSI engine
– Remove bolt -1- using ring spanner insert, 16 mm - V.A.G
1332/14- and adapter - VAS 6948- .
– Pull starter off gearbox slightly but do not remove starter.
– Unscrew remaining bolts -6 ... 10- securing gearbox to engine.
Vehicles with 4-cylinder TDI engine
– Remove bolt -1- using ring spanner insert, 16 mm - V.A.G
1332/14- and adapter - VAS 6948- .
– Pull starter off gearbox slightly but do not remove starter.
– Unscrew remaining bolts -6 ... 9- securing gearbox to engine.
All vehicles (continued)
– Position engine and gearbox jack - VAS 6931- with gearbox
support - T40173- (set up beforehand) underneath gearbox
and secure with tensioning strap -1- as shown in illustration.
– Remove tunnel cross member ⇒ page 74 .
– Detach gearbox from engine and lower carefully using engine
and gearbox jack - VAS 6931- (pay attention to electrical wiring
and SCR line when doing so).
2.2 Installing gearbox
Special tools and workshop equipment required
♦ Ring spanner insert, 16 mm - V.A.G 1332/14-
Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
2. Removing and installing gearbox 61
To Next Page
Loading...
