Audi A4 2015 - Page 67

Note
♦ Renew bolts which are tightened by turning through a speci‐
fied angle.
♦ Renew self-locking nuts and bolts, as well as O-rings, seals
and gaskets.
♦ Secure hose connections with the correct hose clips (as orig‐
inal equipment); refer to ⇒ Electronic parts catalogue .
♦ Re-attach all cable ties at the same locations when re-instal‐
ling.
♦ “Clacking” sound in LuK version dual-mass flywheel with cen‐
trifugal pendulum absorber can be disregarded.
♦ When the clutch module -A- is turned -arrows-, a clacking
sound can be heard at intervals of approx. 90°. This is caused
by moving pendulum masses in the dual-mass flywheel and is
not a fault.
Caution
Risk of leaks on oil pan.
♦ Do not apply gearbox support - T40173- at oil pan.
– Position gearbox on gearbox support - T40173- and secure
with tensioning strap -1-, as shown in illustration.
– The following preparations must be made before joining the
engine and gearbox:
– Insert assembly aid - T40169- into gearbox housing and fly‐
wheel from below, as shown in illustration.
Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
2. Removing and installing gearbox 63