Audi A4 2015 - Page 70

– Remove transportation lock - T40170- .
Note
If the vibration damper -1- is not flat on the drive plate, insert
transportation lock - T40170- and turn crankshaft through 360°
again.
– Tighten first bolt -arrow- to 10 Nm and loosen again; then
tighten to 2 Nm (hand-tight).
– Remove assembly aid - T40169- .
– Secure flywheel to drive plate as follows:
Vehicles with 4-cylinder engine (three securing bolts):
– Using an angled ring spanner, turn crankshaft at vibration
damper 120° further in direction of engine rotation.
– Screw in next bolt in this crankshaft position and tighten
⇒ “2.3 Tightening torques for gearbox”, page 69 .
– Turn crankshaft 120° further in direction of engine rotation,
screw in next bolt and tighten.
– Turn crankshaft 120° further in direction of engine rotation and
tighten final bolt.
Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
66 Rep. gr.34 - Controls, housing