Audi A4 2015 - Page 72

All vehicles:
– Install cover -1-.
Perform remaining installation steps in reverse sequence; ob‐
serve the following:
– Electrical connections and routing ⇒ Current flow diagrams,
Electrical fault finding and Fitting locations.
– Secure drive shafts ⇒ Running gear, axles, steering; Rep. gr.
40 ; Drive shaft; Exploded view - drive shaft .
– Install heat shield for drive shaft ⇒ Running gear, axles, steer‐
ing; Rep. gr. 40 ; Drive shaft; Removing and installing heat
shield for drive shaft .
– Install cover for drive shaft ⇒ General body repairs, exterior;
Rep. gr. 66 ; Wheel housing liners; Exploded view - wheel
housing liner (front) .
– Fit front wheels ⇒ Running gear, axles, steering; Rep. gr. 44 ;
Wheels, tyres .
– Install manual release cable for parking lock ⇒ page 29 .
– Install coolant pipe for gearbox ⇒ Engine; Rep. gr. 19 ; Cool‐
ant pipes; Exploded view - coolant pipes .
– Install intermediate steering shaft ⇒ Running gear, axles,
steering; Rep. gr. 48 ; Steering column; Removing and instal‐
ling intermediate steering shaft .
– Install propshaft ⇒ Rear final drive; Rep. gr. 39 ; Propshaft;
Removing and installing propshaft .
– Install emission control module ⇒ Engine; Rep. gr. 26 ; Emis‐
sion control system; Removing and installing emission control
module .
– Install front exhaust pipe ⇒ Engine; Rep. gr. 26 ; Exhaust
pipes/silencers; Removing and installing front exhaust pipe .
– Install subframe cross brace ⇒ Running gear, axles, steering;
Rep. gr. 40 ; Subframe; Removing and installing subframe
cross brace .
– Fill up with coolant ⇒ Engine; Rep. gr. 19 ; Cooling system/
coolant; Draining and filling cooling system .
– Install engine cover panel ⇒ Engine; Rep. gr. 10 ; Engine
cover panel; Removing and installing engine cover panel .
– Observe measures required after connecting battery ⇒ Elec‐
trical system; Rep. gr. 27 ; Battery; Disconnecting and con‐
necting battery .
– Check MTF level and top up as required ⇒ page 86 .
– Check ATF level and top up as required ⇒ page 91 .
Note
It is not necessary to check the MTF/ATF level if a brand new
gearbox is being installed.
Note
If renewing the gearbox, run the function “Replace control unit” in
⇒ Vehicle diagnostic tester.
Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
68 Rep. gr.34 - Controls, housing