• .___ H_o_m_ e_L_i_n_k_®_R __________________________________________________ _
App li es to vehicles: w it h Homelin k® un ive rsal remote contro l
Programmi n g th e Hom e Link ® tr a nsmitt e r
The transmitter is programmed in two phases. For rolling
code transmitters, a third phase is also necessary .
Fig. 151 Overhead
console : Homelink®
keypad
Fig.152 Frontbumper,
driver side: location of
transmitter unit
Phase 1: programming the overhead keypad
1. Make sure your vehicle is w ithin operat ing range of the
remote controlled garage door opener .
2. Set the parking brake =>
& in "General information" on
page 139.
3. Turn the ignit ion on. Do not sta rt the engine!
4. Press and ho ld the two outside Homelink® buttons
(D
and @ for app roximately 20 seconds until indicator
light © =:> fig.
151 beg ins to flash. Then release both
buttons . Do not hold the buttons for longer than
30
seconds.
This procedure only needs to be performed
once. It
erases the factory-set default codes and does not have to
be repeated to program additional remote controls.
5. Press and hold the Homelink ® button (D, ® or @ until
the indicator light © starts flashing
slowly. Release the
button.
- The system will remain in programming mode for 5
minutes.
Go to the front of the vehicle and proceed with
phase 2.
Phase 2:
programming the bumper mounted transmitter
6. Hold the original remote control at a distance between 0-
6 in. (0-15 cm) from the bumper below the appropriate
headlight for your veh icle => fig.
152 (use the shortest
distance possible) .
7. Aim the remote control just below the
driver side head-
lig ht.
8. Press and hold the act ivation button on the remote
control.
- May be different in Canada . If so, press and re-press
(cycle) the activation button on your remote control every
two seconds. -.,
To Next Page
Loading...
