Audi A4 Cabriolet 2009 - Page 159

To provide extra safety, the rollover protection system is also acti-
vated in head -on, side and rear -end collisions if the impact is severe
enough. •
Lowering the rollover protection bars after
deployment
Lower the rollover protection bars only if the bars were
automatically deployed without the vehicle actually
colliding or overturning.
0
9
:,:
"' m
~
"' 0
±
"' m
Fig. 159 Extended roll-
over bar with release
lever.
Fig. 160 Rollover bar
with the power top
base frame raised
straight up
If the rollover protection system deployed the rollover bars
without the car actually overturning or colliding, you can
lower the roll bars yourself without having to use a special
Safety first
Driving Safely
tool. Once it has been lowered, the rollover protection
system is once again fully operational. If you do not feel
comfortable doing this sort of work, have it done by a
professional mechanic.
With the power top open
- Push the lever=> fig. 159 downward to the left in the
direction indicated by the arrow and keep holding it
down.
- Now simultaneously push the rollover bar down.
Release the lever an inch or two before you push it back
in completely.
- Then press the rollover bar all the way down until you
hear it engage.
- Check to make sure the rollover bar is securely engaged
before you release your grip on the bar.
- Close the cover @ => fig. 160.
- Perform the same procedure on the second rollover bar.
With the power top closed
- Turn on the igni t ion .
- Press the power top switch to raise the base frame with
the rear window until it stands straight up => fig. 160.
- Press the leve r=> fig. 159 down and to the left in the
direction indicated by the arrow and keep holding it
down.
- Now simultaneously push the rollover bar down.
- Release the lever an inch or two before you push it back
in completely. .._.
~ehicle care irechnical data