Op e nin g and c lo s in g
H ow is th e a nt i-th eft a la rm sw it c h e d off w he n
t riggered ?
The alarm system is switched off when you unlock the vehicle using
the remote control or when the ignition is switched on. The alarm
will also switch itse lf off when it comes to the end of its cycle.
Em e rg en cy fla s he r
The emergen cy flashe r will blink briefly when the doors, engine
hood and rear lid are properly closed .
If the emergency flashers do not blink, check the doors, engine hood
and rear lid to make sure they are properly closed . If you close a
door, the hood or the rear lid w ith the anti-theft alarm switched on,
the emerg ency flashers will blink only aft er you have clos ed the
door or lid.
[ i ] Tips
• For the anti -theft alarm system to function properly, make sure
all vehicle doo rs and windows are closed before leaving t he vehicle .
• When you open the vehicle from the driver's door using the key,
the central locking switch will work only aft er you have swi t ched on
the ignition. •
Tilt sensors
~
The tilt sensors trigger an alarm if they detect vehicle
movement.
N
ij
:c
.,
"'
Fig. 49 Driver's door,
rear botto m: ti lt sensor
switch
Sw itch off the tilt sensors if you are go in g to have your
ve hicle tr ansported .
Switch off the tilt s e nsors
- Press the switch A located in the driver's door => fi g. 49 .
Lock the ve hi cle.
When you turn off the tilt sensors, the diode in the switch -lQ wi ll il lu-
minate. Also , the indicator light in the driver's door wil l illuminate
for about three seconds . After you lock the vehicle, the indicator
light in the door trim will blink quickly for about three seconds . After
that, the blinking slows down.
The next time the vehicle is locked, the tilt sensors are automatically
turned on again . •
To Next Page
Loading...
