P o w e r t op
Variable power top storage bay
The bottom of the variable storage bay can only be raised
when the top is closed and NOT folded up inside the bay.
Lifting th e stor a g e bay bas e
Fig. 55 Luggage
comp artm ent : variable
storage bay, bottom
dow n
Fig. 56 Luggage
comp artm ent: varia ble
storage bay, bott om up
Move the lever to position @ to raise the storage bay
bottom =>
page 64, fig. 55.
Lowering the storag e bay bas e
- Move the lever to pos ition @ to lower the var iable
storage bay => f ig. 56.
The storage bay bottom can only be lifted when the top is closed
and NOT folded up inside the bay.
This creates more space in the
luggage compartment . The storage bay base must be in the lowered
position before the top can be lowered.
When the top
opens it folds down completely into the storage bay
des igned to contain it. Only with the storage bay expanded is it
poss i ble to open the top . This feature prevents the top from forcing
its way down agains t objects blocking its storage space . For this
reason your vehicle has less luggage capacity when the top is down
than when it is up and closed . It is not possible to lift the base of the
storage bay when it contains the folded down top . •
Messages in the instrument cluster display
If the power top fails to activa te when you operate the
control switch, a message will appear in the display to
indicate what is wrong.
Before the power top can start to open or close automatically, a
number of conditions must be met . The systems checks, for
instance, if the storage bay has been expanded before the power
top opens.
The instrument cluster disp lay will generate a message if one of
these condi t ions does not check right or if a malfunction occurs .
Power top : ple as e c lo s e rear lid
The lid on the trunk must always be closed when opening or closing
t he power top . This message will appear in the display if the trunk
lid is not closed .
Power top: pl ea se low e r stor a ge ba y
The variable storage bay must be in the lowered (expanded) posi -
tion before the power top can be opened => page 64. This message
will appear in the display if the variable storage bay is not in the
lowered position (lever to the right) when opening the power top. ..,
To Next Page
Loading...
