Audi A5 2016 - Coolant Pump;Coolant Thermostat

– Remove bolts in the sequence -25 ... 1- and detach oil pan.
Installing
Installation is carried out in reverse order; note the following:
Note
Renew gasket and ATF pipe after removal.
– Install ATF cooler ⇒ page 83 .
– Install subframe cross brace ⇒ Running gear, axles, steering;
Rep. gr. 40 ; Subframe; Removing and installing subframe
cross brace .
Tightening torques
♦ ⇒ Fig. ““Oil pan - tightening torque and sequence”“ ,
page 100
10.3 Removing and installing mechatronic
unit
Special tools and workshop equipment required
♦ Vehicle diagnostic tester
Removing
WARNING
System is pressurised.
• Deactivate ATF pump and discharge hydraulic accumu‐
lator before removing oil pan.
– Using vehicle diagnostic tester , discharge ATF accumulator
in automatic gearbox control unit - J217- and disable gearbox
auxiliary hydraulic pump - V552-
⇒ “4.3 Deactivating ATF pump and discharging hydraulic ac‐
cumulator”, page 7 .
– Remove subframe cross brace ⇒ Running gear, axles, steer‐
ing; Rep. gr. 40 ; Subframe; Removing and installing subframe
cross brace .
– Remove oil pan ⇒ page 100 .
All further work on the mechatronic unit is described in ⇒ Serv‐
icing 7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP;
Rep. gr. 34 ; Mechatronic unit; Removing and installing mecha‐
tronic unit .
Installing
Installation is carried out in reverse order; note the following:
– Install subframe cross brace ⇒ Running gear, axles, steering;
Rep. gr. 40 ; Subframe; Removing and installing subframe
cross brace .
Tightening torques
♦ ⇒ Servicing 7-speed dual clutch gearbox 0CJ, 0CK, 0CL,
0DN, 0DP; Rep. gr. 34 ; Mechatronic unit; Exploded view -
mechatronic unit
Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
102 Rep. gr.34 - Controls, housing