8 Gear oil
⇒ “8.1 Checking gear oil level”, page 86
⇒ “8.2 Draining and filling gear oil”, page 87
8.1 Checking gear oil level
Special tools and workshop equipment required
♦ Socket Torx T60 - T40087-
♦ Safety goggles
Procedure
Note
♦
General repair instructions ⇒ page 6 .
♦
Rules for cleanliness ⇒ page 6 .
♦
Always use the correct fluid for the different parts of the gear‐
box: gear oil (MTF) system and ATF system.
♦
Renew plug for inspection and filler hole.
• Gear oil about 20 °C (room temperature).
• Vehicle must be absolutely horizontal (drive it onto a four-pillar
lifting platform or over an inspection pit).
• The vehicle must be stationary with the engine switched off for
at least 15 minutes to allow the oil level to stabilise.
– Remove noise insulation (rear) ⇒ General body repairs, ex‐
terior; Rep. gr. 66 ; Noise insulation; Removing and installing
noise insulation .
– Depending on equipment version: Remove bolts -arrows- and
nut -2-.
– Detach end plate -1- for cross brace.
WARNING
Risk of eye injury.
♦ Put on safety goggles.
Audi A4 2015 ➤ , Audi A4 Avant 2015 ➤ , Audi A4 China 2016 ➤ , Audi A4 a ...
7-speed dual clutch gearbox 0CJ, 0CK, 0CL, 0DN, 0DP - Edition 08.2018
86 Rep. gr.34 - Controls, housing
To Next Page
Loading...
