EasyManua.ls Logo

Audi A6 2011 - ATF Pump, Deactivating and Draining the Hydraulic Pump Reservoir; Contact Corrosion

Audi A6 2011
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
4.3 ATF Pump, Deactivating and Draining
the Hydraulic Pump Reservoir
WARNING
The system is under pressure.
The ATF transmission “7 speed S tronic Transmission 0CK” is
equipped with an electronic ATF pump and a hydraulic pres‐
sure reservoir.
The electronic ATF pump can start up at any time.
The ATF system also remains under pressure with the ignition
switched off due to the hydraulic pressure reservoir.
The electronic ATF pump must be deactivated every time
before opening the transmission, and the hydraulic pres‐
sure reservoir is drained.
When the system status is not clear, for example the
cause of a faulty transmission control module or transmis‐
sion is unknown, only loosen the mechatronic bolts to a
minimal degree, so that the oil pressure in the pressure
reservoir can decrease slowly.
Disconnect the Transmission Control Module - J217- con‐
nector before removing the oil pan.
Wear protective eyewear.
ATF Pump, Deactivating and Draining the Hydraulic Pump Res‐
ervoir
Connect the Vehicle Diagnostic Tester with the vehicle and
start the Diagnostic mode.
Select Vehicle Test
02-Transmission Electronics, Functions
02 ATF Pressure Reduction/Disabling the ATF Pump or
02-ATF Level
Draining ATF
4.4 Contact Corrosion
Contact corrosion can occur if unsuitable fasteners (bolts, nuts,
washers, etc.) are used.
For this reason, only fasteners with a special surface coating may
be installed.
Furthermore, only rubber/plastic parts and adhesive made of
electrically non-conductive materials are used.
If there are doubts about whether parts can be used or not, then
use new parts. Refer to the Parts Catalog.
Note
Only original replacement parts are recommended, they are
checked and compatible with aluminum.
The use of Audi accessories is recommended.
Damage resulting from contact corrosion is not covered by the
warranty.
Audi A6 2011 ➤ , Audi A6 Avant 2011 ➤ , Audi A7 Sportback 2011 ➤ , Audi ...
7-Speed Dual Clutch Transmission 0CK - Edition 11.2015
4. Repair Information 7

Other manuals for Audi A6 2011

Related product manuals